Note: The individual JTAG-SMT3-NC is MSL 6. We also offer
MSL 3 versions in 40 unit trays. Please contact our sales department at email@example.com for MSL 3 tray purchasing options.
Bulk discounts available.
The Joint Test Action Group (JTAG)-SMT3-NC is a compact, complete,
and fully self-contained surface-mount programming module for Xilinx
field-programmable gate arrays (FPGAs). The module can be accessed
directly from all Xilinx Tools, including iMPACT, ChipScope™, Vivado,
and EDK. Users can load the module directly onto a target board and
reflow it like any other component.
The JTAG-SMT3-NC uses a 3.3V main power supply and independent Vref
supplies to drive the JTAG and UART signals. All JTAG signals use high
speed 24mA three-state buffers that allow signal voltages from 1.8V to
5.5V, and bus speeds up to 30MBit/sec. All UART signals use high speed
24mA buffers that allow signal voltages from 1.8V to 5.5V and bus speeds
up to 12Mbaud. The JTAG bus can be shared with other devices as the
SMT3-NC signals are held at high impedance, except when actively driven
during programming. The SMT3-NC module is CE certified and fully
compliant with EU RoHS and REACH directives. The module routes the USB
D+ (DP) and D- (DM) signals out to pads, providing the system designer
with the ability to choose the type of USB connector and its location on
the system board.
Small, complete, all-in-one JTAG programming/debugging solution for Xilinx FPGAs with UART side channel
Compatible with Xilinx Tools
High-Speed USB 2.0 port that can drive JTAG bus up to 30Mbit/sec (frequency settable by user)
Open drain buffer on PS_SRST_B pin allows debugging software to reset the processor core of Xilinx’s Zynq® platform
Dual channel USB controller provides simultaneous access to both JTAG and UART interfaces
Separate Vref for JTAG and UART signals allows each interface to operate at different voltages (1.8V to 5.5V)
Small form-factor surface-mount module can be directly loaded on target boards
USB D+ and D- signals routed to pads, allowing USB connector to be placed anywhere on the host PCB
VBUS_DETECT pin allows for reduced current consumption when the module isn’t connected to a PC