The VmodCAM board provides digital imaging capabilities for any Digilent
FPGA system board with a VHDCI connector. It features two Aptina
MT9D112 2-megapixel CMOS digital image sensors. The sensors can provide
frame rates from 15 FPS upwards, depending on the resolution.
Its system-on-a-chip design integrates an image flow processor and
enables selectable output formats, scaling, and special effects. The
integrated PLL (phase-locked loop) and microprocessor offer a flexible
serial control interface. The output data is sent on a parallel bus in
processed YCrCb, RGB, or raw Bayer formats.
The two MT9D112 cameras can be controlled independently and can acquire
two separate, simultaneous image feeds. They are controlled by a
two-wire interface. Each camera has a 2 megapixel color sensor array in
Bayer color filter arrangement. The sensor readout is 10-bit and
supports skipping or binning rows/columns.
NOTE: To connect to a system board, this product requires a
male-to-male VHDCI cable, which is not included. These cables can be found in the cables category.
- Two independent Aptina MT9D112 2-megapixel CMOS digital image sensors
- 1600x1200 maximum resolution at 15 FPS
- 63mm inter-camera spacing (stereo baseline)
- 10-bit raw color depth
- I2C control bus
- Bayer, RGB, YCrCb output formats
- Automatic exposure, gain, and white balance
- Powerful image correction algorithms
- Image scaling
- Output FIFO
- 68-pin female VHDCI connector
|2x Aptina MT9D112
Support documents can be found at www.digilentinc.com